C8051F380-TB【PDF 95/321 页】DEV KIT FOR C8051F38X

您好，
买卖IC网欢迎您。
请登录
免费注册

91页 92页 93页 94页 [95页]96页 97页 98页 99页

C8051F380/1/2/3/4/5/6/7/C

14.3. Configuring the External Memory Interface

Configuring the External Memory Interface consists of five steps:

1. Configure the Output Modes of the associated port pins as either push-pull or open-drain (push-pull is

most common), and skip the associated pins in the crossbar.

2. Configure Port latches to “park” the EMIF pins in a dormant state (usually by setting them to logic 1).

3. Select Multiplexed mode or Non-multiplexed mode.

4. Select the memory mode (on-chip only, split mode without bank select, split mode with bank select, or

off-chip only).

5. Set up timing to interface with off-chip memory or peripherals.

Each of these five steps is explained in detail in the following sections. The Port selection, Multiplexed

mode selection, and Mode bits are located in the EMI0CF register shown in SFR Definition 14.5.

14.4. Port Configuration

The External Memory Interface appears on Ports 4, 3, 2, and 1 when it is used for off-chip memory access.

When the EMIF is used, the Crossbar should be configured to skip over the control lines P1.7 (WR), P1.6

(RD), and if multiplexed mode is selected P1.3 (ALE) using the P1SKIP register. For more information

about configuring the Crossbar, see Section “Figure 20.1. Port I/O Functional Block Diagram (Port 0

through Port 3)” on page 153.

The External Memory Interface claims the associated Port pins for memory operations ONLY during the

execution of an off-chip MOVX instruction. Once the MOVX instruction has completed, control of the Port

pins reverts to the Port latches or to the Crossbar settings for those pins. See Section “20. Port Input/Out-

put” on page 153 for more information about the Crossbar and Port operation and configuration. The Port

latches should be explicitly configured to ‘park’ the External Memory Interface pins in a dormant

state, most commonly by setting them to a logic 1 .

During the execution of the MOVX instruction, the External Memory Interface will explicitly disable the driv-

ers on all Port pins that are acting as Inputs (Data[7:0] during a READ operation, for example). The Output

mode of the Port pins (whether the pin is configured as Open-Drain or Push-Pull) is unaffected by the

External Memory Interface operation, and remains controlled by the PnMDOUT registers. In most cases,

the output modes of all EMIF pins should be configured for push-pull mode.

Rev. 1.4

95

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

我的联系方式

*

*

*

相关PDF资料

C8051F912DK KIT DEV FOR C8051F91X/C8051F90X

C8051F930-TB BOARD TARGET/PROTO W/C8051F930

C8051T610DB24 DAUGHTER BOARD T610 24QFN SOCKET

C8051T630DB20 BOARD SOCKET DAUGHTER 20-QFN

CAN-100 BOARD EVAL RS232 100QFP

CANADAPT28 KIT ADAPTER CANDEMOBOARD 28PLCC

CAT24AA01WI-GT3 IC EEPROM SERIAL 1KB I2C 8SOIC

CAT24AA02WI-G IC EEPROM SERIAL 2KB I2C 8SOIC

相关代理商/技术参数

C8051F381 制造商:SILABS 制造商全称:SILABS 功能描述:USB DRIVER CUSTOMIZATION

C8051F381-GM 功能描述:8位微控制器 -MCU USB-64K-Flash RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT

C8051F381-GMR 功能描述:8位微控制器 -MCU USB-Flash-64k-ADC RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT

C8051F381-GQ 功能描述:8位微控制器 -MCU USB-64K-Flash RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT

C8051F381-GQR 功能描述:8位微控制器 -MCU USB-Flash-64k-ADC RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT

C8051F382 制造商:SILABS 制造商全称:SILABS 功能描述:USB DRIVER CUSTOMIZATION

C8051F382-GQ 功能描述:8位微控制器 -MCU USB-Flash-32k-ADC RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT

C8051F382-GQR 功能描述:8位微控制器 -MCU USB-Flash-32k-ADC RoHS:否制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT